Access Music User Forum

You can emulate verislope filters by using the two per-note filters in the filter section. Set one to HP and the other to LP but make sure both are on the same cutoff frequency (e.g. cutoff link + filter 2 on "+0"). Now in order to "move" the varislope, change the filter balance. Also, try this with both serial and parallel routings, in order to see how it influences the filter balance middle position.
Hope this helps.

Ahem.... OK sorry, still learning the new jargon. Try this then: set filter 1 to whatever type of varislope filter you intend to use (because it can be 4 or 2 poles, or from 1 to 4 LP in moog emulation mode), filter 2 to "all pass", meaning highpass with cutoff at 0 or lowpass with cutoff at 127, filter routing to parallel, then modulate filter balance. Serial routing should also yield an interesting result.